Thermal Insulation PU Sandwich Panel Machine for Various Thickness
Specification of PU sandwich panel machine
|Three sets of roll forming machine||1. Function: Roll forming for the profiles of PU panel|
2. Use the welding H-beam, motor driver, sprocket chain driving
3. Technical data: Material of roller NO.45forged steel, with digital
controlled procession,plated with hard chrome on surface of forming
|PU sandwich Panel foaming line||1. Two sets of conveyor rack: up conveyor is about 24m, down conveyor
is about 30m.They lead the steel sheet from the roll forming
machine to preheating room and to foaming,to cutting.|
2. One preheating room: It is built by heat-insulation material, and
it could heat up the steel sheet to 25-38 by heater.
3. One set of PU two component Liquid mixing and injecting section
for foaming : it adopt Chinese high pressure pump. It have the
temperature control system and material-level monitoring system.
The tank of the material is about 150L. Two tanks.
4. Foaming and double rubber device include motor driver system to
5. The width of belt board is 1250mm, the range of adjusting distance
between upper and lower frame belt board: min 25mm, max 200mm. And
the range of adjusting thickness of sandwich panel
:30mm,50mm,100mm.(30-50 for celling , 50-100 for wall)
|Panel automatically cutting system||1. Cutting machine can move 2500mm longitudinally along product
line;fly saw of the cutting machine can move transversely 1900mm,
Cutting machine moves longitudinally and transversely along the
2. Cutting machine adopts one-side blade band saw manner, cutting and
revolving after cutting. The cutting saw can revolve, so cutting in
two directions is realizable.
3. There is panel tight-pressing system (pneumatic) in the cutting
4. There is location limiter to limit longitudinal and transverse
motion of cutting machine.
|Electric control system||1. The control system adopt the touch screen , PLC , module control
and transducer. The control system adopt Panasonic(JAPAN) product.|
2. There one control platforms and electric trunk by which operating
and controlling the electric motors and all motions (including
hydraulic and pneumatic) in the product line.
3. Intercalated appropriate amount of portable switch on the product
line, so manual operation get convenient.
4. Alarm and emergency stop system should be installed in the product
line in case accident happens
Thickness of steel plate: 0.35-0.6mm
Thickness of Core Material: 20mm, 30mm, 40mm, 50mm, 60mm,75mm,
100mm,150mm, 200mm, 250mm, 300mm
Color: White grey, Sliver, Sea Blue, Red, etc
Introduction of Machine
- This PU Sandwich panel production line is an automatic production
- In the PU sandwich panel producing procedure, the product line can
continuously produce sandwich panel with PU as its core material.
- The liquid state raw materials were continuously injected into the
middle of three formed panels and reacting, foaming, solidifying in
the double-rubber .
- The PU sandwich panel could be cut out automatically according to
the required length for users.
For more information, please contact us freely.